Painting A Sliding Door

Painting a vinyl door requires the use of a primer containing a bonding agent followed by coats of a special latex paint containing a bonding agent.

Painting a sliding door.

If they are metal steel sand lightly to get rid of any dust etc. Clean the door thoroughly with. Open your door as wide as possible to reveal the hinges holding it to the doorframe. Spray the entire door this way.

Tape off the outside border of the door frame with more wrapping paper. Shake a can of exterior grade spray paint to mix the paint. Hit the nail with a hammer until the hinge pin loosens and the top is pushed away from the hinge panels. Secure old wrapping paper to the border of each piece of glass with painter s tape.

Instructions use the multi purpose cleaner to clean the doors and sliding track really well. Locate the screw near the bottom edge of the sliding door insert a screwdriver and turn it counterclockwise to. Cover the floor with an old sheet. Before you get started know that paint drying times and environmental factors can.

Lift up and pull the. Protect glass image zoom carefully mask off the glass with blue painter s tape. Spray a light. If possible mask both sides of.

Painting sequence for a sliding door step 1. How to paint a wood sliding glass door 1. Spray the door lightly back and forth overlapping the paint strokes to encourage an even application. Now on the doors.

How to paint metal windows and doors. Remove the door if possible. Painting aluminum windows and doors is explained here. Slide the insect screen to the middle of the door s frame and grasp both sides of the screen.

The special primer and paint trigger a chemical reaction that essentially melts the surface of the door allowing the primer and paint to bond with the vinyl surface to create a durable finish. Then apply a good primer and then a couple of coats of the color of paint of your choice in an exterior paint. Remove hardware and protect areas you do not wish to paint. Press a nail to the base of the hinge pin which will be right on the point where the door pivots open and closed.

The proper was to paint metal doors and windows using dtm indust.