My Invisible Fence Transmitter Is Beeping

The manufacturer is invisible fence.

My invisible fence transmitter is beeping.

I cannot find my owners manual to see how to turn the alarm off. At invisible fence brand we welcome your questions. To begin with the installation of the cable it will be necessary to open incisions in the ground and connect the cable according to the spaces that you wish to cover. After calling the company i was informed that this alarm meant there was a break in the fence and that i should have them come out as soon as possible because my dog would surely figure this out in a few days.

The wire break alarm does not know where why or when but the two ends of the same wire which plug into the transmitter are not intact not part of a. Tune a portable radio to the frequency your invisible fence uses. Usually a sound coming from your wall mounted transmitter is the wire break alarm signaling damage to the perimeter wire. Wireless dog fence not emitting an audible beep.

The fence wires should be attached to the leads close to where they join the coils. It is recommended that you just replace both items. You will know you have the right frequency when you hear fast tapping or beeping through the radio. Once the limits are decided get to work.

In this case either the transmitter is burned out or the plug in transformer is bad. The transmitter box starts to beep to notify you that your dog left the yard. Since the fence line is invisible the level of difficultly in locating the break in the fence increases. My transmitter lit up.

Chances are you just need to replace the surge protector. Recently i went into my garage to find the invisible dog fence transmitter beeping. Before buying an invisible fence it is. If there is a break in the fence the transmitter box will beep nonstop until the break is located and repaired.

Electric dog fence transmitter beeping. Install the transmitter and cable. My transmitter still doesn t light up. It protected your dog fence transmitter.

The transmitter box is located in my basement. Take a look at some of the troubleshooting questions other happy customers asked or call 866 804 1250. If the invisible fence beeping started after a storm it still may not be a damaged transmitter it may be a fault from the wet ground the best way to test this is to pull the pair of wires out of the transmitter and put in a small loop of wire into the same 2 slots you removed the pair from. The bad surge protector did its job.

Walk the perimeter of the invisible fence and look for drops in the signal.